Trimlock for the Prowler 13

Click here to read the HOOK 1 Disclaimer

Click on images to view larger

This is for the new hatch gasket available for the Prowler 13 to replace the neoprene skirt that fits under the hatch lid.  My gasket came with no instructions.  Having now done it, here is what worked for me.

Have the gasket warm.  It was cold this morning so I put mine in a net bag (sweater/ lingerie?) and tossed it in with the morning’s laundry, in the dryer on low, for a few minutes.

Locate the end of the gasket with the extra tongue.  You will begin with this end.  Begin at the side of the hatch (this will make it easier to line up the ends when they come together) and slide the bottom slit over the hatch rim.  The soft, tubular top is up towards you.  The flat edge is on the inside of the kayak.

 The slit is tight.  Take your time working it back and forth across the edge of the hatch opening.  If you crimp the edge, warm it up a bit and work it back open with a soft plastic implement such as a plastic spackle knife.  Once you have a section slid on, gently tap it firmly into place with a rubber mallet.  This is especially important on the curve along the front edge of the hatch as it will slide part way on but not be fully well seated.  As you continue on, if it wasn’t well seated, the tension will prevent you from seating it.  So, do it well as you go.

Continue all around the hatch until the two ends meet.  Slide your working end as well on as you can so as to get a good measure for where to cut off the excess.  Cut with a sharp pair of heavy, utility shears.  Stick the tongue in the roll, re-slip the end over the last bit of hatch lip and you are done.

Thank you to Pat Grant for sending in the above instructions/help.